C1-7
B
A
Front
Inside!!
D
Outside!!
STEP1
Lay the sidepieces (A) with the curved sides uppermost on a flat surface. Place slat
(B) for the seat in the last notches at the back and on the top of parts (A). Keep
the curved side with the notches facing the back and the countersunk edges of the
pre-drilled holes facing upwards. Secure the slat with a 4x40 mm screw on each
side, keeping it flush. Take one of the (C) slats and place it precisely in the first
notches at the front of the sidepieces. Secure the slat using a 4x40 mm screw on
each side. The pre-drilled holes should be facing upwards. Now place one of the
(C) slats in the third notch from the bottom. Secure this in the same way.
STEP 2
Now place all the remaining slats C 1 - 7 in the notches on top of sidepieces (A).
Make sure that they fit properly. The outermost edges of the slats should be flush
with the outermost edges of the notches. The countersunk edges of the pre-drilled
holes should face upwards. Now secure all the slats using 4x40 mm screws.
STEP 3
Now attach the back legs (D). Put two nuts in the large pre-drilled holes at the
back of sidepiece (A). Take legs (D) and attach these with the bolts to the outside
of sidepiece (A). Make sure that you are using the
back
legs! The two small pre-
drilled holes should be at the bottom of the legs, with the countersunk edge facing
outwards. Repeat on the other side of the chair.
