28
CAN Srl
–
CU 3002
–
ENGLISH
–
Rev 1/2018
IGNITING THE BURNERS
1)
(Fig. 11-12-14) Fully press the button corresponding to the burner you want to
ignite and at the same time turn it to the maximum symbol.
2)
At the same time, activate the electrical ignition device by prolonged
pressing on the button positioned on the commands front panel. The
generator will emit a rapid and repeated series of impulses.
3)
After igniting, keep the knob fully pressed for approx. 5 seconds, always
pressing to the max and then releasing it: this release delay is used to heat the
safety thermocouple.
If on release of the knob, the burner does not stay on, it means the thermocouple
was not sufficiently pre-heated. To solve the problem, repeat operations 1) and
2) and 3) keeping the knob pressed for longer after igniting the burner.
ATTENTION
–
Ignition must take place without any pots or other objects
on the hob and on the burners
FLAME ADJUSTMENT
4) Check the flame is regular and stable. Then, turn the knob to the desired position
(MIN or MAX). You can position the knob in the intermediate position, between the
maximum and minimum, but NOT between the maximum and “closed” position (0°
angle) (Fig. 12). If the flame is irregular, check the correct positioning of the gas rings
and the caps.
COOKING
5) Position tins for baking on the burner when on; never leave burners on without
containers or with empty containers.
Only use saucepan, pans and accessories expressly design for this use, made from
materials resistant to high temperatures and suitable for contact with food.
For more efficient burners, you are advised to use containers with a
diameter suitable for the type of burner chosen, to obtain maximum
performance with minimum gas consumption (Fig.15).
