CAN AIRXCEL FC Series, Инструкция по эксплуатации и обслуживанию

Страница: 142 / 404

140
ENGLISHENGLISH
GAS HOB UNITS WITH GLASS RECESSED LID
▪
FC series
use of burners
OFF
MAX
MIN
LIGHTING THE BURNERS
ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
burner spreader positioning
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually
using the external igniter (on S versions),
▪
electronically
with 12 V/DC generator (on E versions),
▪
piezoelectrically
with mechanically/manually operated piezoelectric igniter (on P versions).
Proceed as follows to light the burner :
step action
1 press the knob corresponding to the burner you want to light
and turn it anticlockwise (to the maximum symbol).
2 At the same time, activate the flame ignition device by:
- putting an external igniter near the flame spreader (version
S)
- pressing the piezoelectric button repeatedly (version P)
- pressing the electronic ignition button continuously
(version E)
The models FC1380-81 are equipped with under-knob
electronic ignition: the spark is ignited by simply pressing the
knob
3 When lit, keep the knob pressed all the way for another 5
seconds (at maximum) and then release it, adjusting the
desired intensity of the flame.
Please note:
this delay in releasing the knob heats up the
safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple did not heat
up sufficiently. To solve this problem, repeat the operations described in the table, holding the knob down
longer after the burner is lit.
1
2