CAN AIRXCEL FC Series, Инструкция по эксплуатации и обслуживанию

Страница: 120 / 404

118
ENGLISHENGLISH
GAS HOB UNITS WITH GLASS RECESSED LID
▪
FC series
INSTALLATION ON SUPPORT STRUCTURE
The appliance must be mounted on a support structure, made of material fire-retardant and resistant to
heat and with all of the sturdiness requirements indicated by the technical sector standards (for example
EN14749).
The work table must be perfectly horizontal and perpendicular to all surrounding vertical panelling.
The area near the appliance could get very hot. Pay the utmost attention and do not place sockets, other
household appliances, power cables, piping and any other heat-sensitive or flammable material in this area.
ATTENTION!
The appliance must be installed in a room without air draughts which can have a negative
effect on combustion. The chosen installation position must also prevent the accumulation of
unburnt gases.
Comply with the sizes indicated in this manual. Any deviation could cause the temperature to rise excessively.
The surrounding surfaces must be able to withstand temperature rises admitted by standard EN30-1-1 and in
compliance with the design of this unit. All combustible material, such as curtains and shelves, must be kept
far away from the appliance. Check the admissible temperature of the materials used for the surrounding
surfaces to guarantee their compliance with the requirements of EN30-1-1.
RECESSED HOLE
The support structure must be provided with a suitable recessed hole. For information regarding the
dimensions of the hole of your model, refer to the table below and follow the drawings in the technical data
sheets of each model in the first section of this manual.
recessed hole sizes
model a
[mm]
b
[mm]
Ø
[mm]
FC1336
520 320 -
FC1337
320 520 -
FC1338 520 320 -
FC1343 460 460 -
FC1344
460 460 -
FC1345
- - 310
FC1347
405 405 -
FC1348
460 340 -
FC1349 700 320 -
FC1350 700 320 -
FC1351
700 320 -
FC1352
748 310 -
FC1380 690 310 -
FC1381 690 310 -
Refer to the drawings in the TECHNICAL DATA SHEETS for the recessing details of each model.