CAN CHECKED MCE18, Руководство пользователя

Страница: 9 / 17

Rev 1.0
9
You can set the transfer rate, the Can Bus speed, and the addresses for sending and receiving the Can
Bus messages. As always, the Can Bus speed is identical in ECU and MCE18. In the following table you
will find the exact addresses of the individual inputs and outputs in the standard protocol.
Byte 0 1 2 3 4 5 6 7
TX
Base
ID AIN0 0-1023 AIN1 0-1023 AIN2 0-1023 AIN3 0-1023
TX
Base
ID +1 AIN4 0-1023 AIN5 0-1023 AIN6 0-1023 AIN7 0-1023
TX
Base
ID +2 AIN8 0-1023 Bit
masked
DIN0-7 Bit
masked
AUX1-3 internal
Temp version
TX
Base
ID +3 FreqIn1 0-60000 FreqIn2 0-60000 FreqIn3 0-60000 FreqIn4 0-60000
Furthermore, you can also configure the 20-50 kOhm software pullups for the digital and analog
inputs in Settings. You can switch between OFF and ACTIVE.
If the internal pull-up is activated, the digital input should be switched to ground. If it is not activated,
the input can be switched to 5 or 12V. The "HIGH" state corresponds to a 1 on the Can bus.
Furthermore, under the item AIN smoothing you will find the possibility to calm your analog inputs.