Rev 1.0
16
6.8
Supports the MCE18 29 bit can IDs
An integration of 29 bit Can IDs has not yet taken place.
6.9
At what rate is the data recorded?
Different sampling rates are possible on the MCE18. You can adjust the frequency from 5 to 250 Hz.
A sampling rate of 50 Hz is recommended to minimize the Can Bus load.
6.10
How to connect a Flexfuelsensor
Connect the flex fuel sensor with the signal to DIN 6. Ground and 5V can be taken directly from the
MCE18. An external resistor is not necessary, it is sufficient to activate the internal pull-up under
Settings. A frequency of 50 Hz corresponds to 0% ethanol. A frequency of 150Hz is 100% ethanol. The
multiplier for the conversion is 1 and the offset is -50. Reading out the temperature is not supported.
