Can-Am Spyder RT 2019, Руководство оператора

Страница: 112 / 187

MAINTENANCE PROCEDURES
NOTICE
Adjusting the oil level on
a cold engine will result in overfill-
ing.
3. Stop the engine.
NOTE: Engine oil level verification
must be performed within 2 minutes
after engine stop.
4. Recheck oil level.
5. Repeat the above steps until oil
level reaches the dipstick between
the lower and upper marks.
Do not
overfill.
6. Properly insert and tighten dipstick.
7. Close seat.
Changing the Engine Oil and Oil
Filter
1. Prior to changing the oil, ensure ve-
hicle is on a level surface.
NOTICE
The engine oil and the en-
gine oil filter must be replaced at the
same time. The oil change should
be carried out with a warm engine.
CAUTION Engine oil can be
very hot.
2. Remove the following RH body pan-
els, refer to
BODY
:
– Middle side panel
– Top side panel
– Acoustic panel.
3. Clean area around drain plug under
oil sump cover.
4. Place an appropriate drain pan under
oil sump cover.
5. Remove the drain plug and discard
the sealing washer and O-rings.
rmr2014-011-301_b
TYPICAL
1. Engine oil drain plug
6. Remove the dipstick.
7. Allow sufficient time for oil to com-
pletely drain.
8. Clean area around magnetic drain
plug in the clutch cover.
9. Place an appropriate drain pan under
the clutch cover.
10. Remove the magnetic oil drain
plug and discard the sealing ring.
rmr2014-011-301_a
TYPICAL
1. Clutch cover magnetic drain plug
11. Remove oil filter cover and discard
its O-rings.
12. Remove and discard oil filter.
110
______________