Can-Am Commander Electric LSV, Руководство оператора

Страница: 47 / 114

SECONDARY CONTROLS
NOTICE
Always turn key to OFF
position when vehicle is not used.
Otherwise, battery drainage will oc-
cur and may lead to permanent fail-
ure of batteries.
ON with Lights
When the key is turned in this position,
the electrical system of the vehicle is
activated.
The gauge should wake-up.
The vehicle lights are turned on.
The motor controller is initialized.
ON
This position offers the same functions
as ON with lights position, except the
vehicle lights are turned off.
Key
The vehicle is delivered with two keys.
The key contains an electronic circuit
that gives it a unique electronic serial
number (digitally encoded security sys-
tem).
The D.E.S.S. system reads the key
code and allows motor operation for
key it recognizes.
WARNING
To prevent vehicle unauthorized
used, always remove key from
power switch.
2) Multifunction Lever
Low/High Beam Selection
When the multifunction lever is in the
middle position, the low beam is se-
lected.
Push the multifunction lever forward to
select high beam.
Pull back the multifunction lever to re-
turn to low beam.
NOTE: The power switch must be set
to ON with lights position to turn on the
headlights.
Headlight Flashing
To flash the high beams while in low
beams, pull on the multifunction lever.
Horn Activation
The horn can be activated by pushing
the end of the multifunction lever to-
ward the steering wheel.
Turn Signal Activation
To activate the LH turn signals, push
down the multifunction lever.
To activate the RH turn signals, push up
the multifunction lever.
Reposition the multifunction lever in
the middle position to stop turn signal.
NOTE: There is no auto-cancel feature
on the turn signals.
3) Hazard Warning Switch
tmo2012-005-044_c
TYPICAL
1. Hazard warning switch
The hazard warning switch is located
on the upper console.
When activated, all the turn signal
lights will flash.
4) 2WD/4WD Switch
4x4 Models Only
The 2WD/4WD switch is located on
the upper console.
44
______________