CAMSO ATV R4S, Руководство пользователя

Страница: 20 / 50

17
MAINTENANCE
MAINTENANCE - TASKS
• Inspect : Component(s) must be examined
with care. If an anomaly is noticed, the
malfunctioning component(s) must be repaired
or replaced.
• Clean : Component(s) must be cleaned of any
dirt, dust or contaminant liable to impair the
proper operation of the Track System.
• Adjust : Component(s) must be adjusted or re-
adjusted according to the manufacturer’s
adjustment recommendations. Refer to the
relevant section of the
User Manual .
• Lubricate : Component(s) need to be
lubricated according to the manufacturer’s
recommendations. Refer to the relevant
section of the
User Manual .
• Replace : Component(s) must be replaced to
avoid serious breakage.
MAINTENANCE - SPECIFICATIONS
System
• Visual Inspection : Visually inspect each
Track System to detect any defect or anomaly
that can impair proper functioning of the
systems.
• Adjustment : Perform or verify angle of attack
adjustments on the systems according to the
manufacturer’s recommendations. Refer to the
Adjustments section on page 9.
• Vehicle Alignment : Perform or verify the
vehicle alignment with the Track Systems
installed. Follow the manufacturer’s
recommendations. Refer to the
Alignment
section on page 12.
• Bolt Torque : Check the torque of critical bolts
identified in the exploded views of the system.
Refer to the central pages of the
User Manual .
CAUTION: Comply with the tightening torque
recommendations and use a thread locker product
if you come across a bolt that is not tightened to
the manufacturer’s recommendations.
Track
• Tension : Perform or check track tension on the
systems according to the manufacturer’s
recommendations. Refer to “Rubber Track
Tension” in the
Adjustments section on
page 14.
• Wear : Check wear and overall condition of the
tracks on the Systems. Refer to “Wear” in the
Maintenance section on page 22.
CAUTION: A damaged track can result in
premature wear of Track System components.
Wheels
• Side Wear : Check side wear on Track System
wheels. Replace wheel(s) if wear is too great.
Refer to “Wear” in the
Maintenance section on
page 22.
• Bearings : Check wheel bearings for
restriction, noise or abnormal play in rotation.
Replace bearing if it shows one of these
defects.
• Wheel Seal Lubrication : Wheel seals must be
cleaned of any dirt or contaminant and
lubricated according to the manufacturer’s
recommendations. Refer to “Lubrication” in the
Maintenance section on page 20. If a seal
shows damage or any defect, it must be
replaced
.
NOTE: Lubrication done at the recommended intervals
allows the wheel seals to maintain optimal
sealing action and prolongs the useful life span
of the wheels.
Frame
• Hub Bearings : Check hub bearings for
restriction, noise or abnormal play in rotation.
Bearings must absolutely be replaced if they
present a defect.
CAUTION: If a hub bearing shows a defect, replace
the both hub bearings and replace hub bearings
on all 4 Track Systems at the same time.