CPB-515 Operation and Maintenance Manual – TTS 70, 80,100, 110 Series (10-2021)
18
5.3 Maintenance Schedule
Task
Daily or
10h
Weekly
or 50h
Monthly
or 100h
Annual
or 500hr
5 years or
2000hr
Inspect and clean track system
X
Inspect track condition
X
Check track alignment
X
Inspect for oil leaks on idler,
midroller hubs, and pivot axles
X
Grease undercarriage and track
system pivot points
X
Check track tension
X
Re-torque wheels
X
Repack carrier roller hub bearings
(if equipped).
*
X
Replace hub and pivot oil and set
wheel bearing rolling torque.
*
X
* Please refer to the Service Manual for detailed instruction
5.3.1 Daily maintenance or every 10 working hours
1. Clean and remove debris from track system. Material build-up on track system
components can lead to excessive wear and premature failure.
2. Track system inspection. Walk around the machine inspecting each track system
and axle assembly. Identifying and resolving issues early is key to improving track
system life and decreasing operating expenses. See “Track System Inspection” in
the Routine maintenance section for more information.
3. Check rubber track alignment daily by inspecting the guide lugs. If excessive wear
or chunking of the guide lug is occurring, track alignment may need to be adjusted.
For additional information, refer to the “Track Alignment Procedure” section.
4. Inspect idler, midroller, and midroller pivot axles for leaks. If any are noted, check
oil level of the hub to be sure oil is up to the fill hole when on a level surface.
