CPB-515 Operation and Maintenance Manual – TTS 70, 80,100, 110 Series (10-2021)
16
11.
Install outer thrust washer, retaining cap and retainer cap bolts & washers. Torque
retainer bolts to 320 Nm (236 ft-lbs)
12.
Repeat steps 7 through 11 for the other of the axle assembly.
13.
Remove jack stands and/or supports and lower implement to the ground.
14.
Install the stabilizer bars (if not required skip to step 15) to a
no pre-load
condition.
Some slight play should be present at the rod ends. In special cases, some
adjustment to the stabilizer bars may be required to achieve the desired front to
rear parallelism dimension
a) For 2 axle midroller systems, attach the two, front stabilizer bars to the
mounting brackets on the axle and the brackets on undercarriage frame with
the hardware provided in the kit. Stabilizer end bolt torque 310 Nm (230 ft-lb)
b) For 4 midroller axle track systems, attach the two, front stabilizer bars and two,
rear stabilizer bars to the mounting brackets on the axle and the brackets on
undercarriage frame with the hardware provided in the kit. Stabilizer end bolt
torque 310 Nm (230 ft-lb)
c)
Torque turnbuckle jam nuts to 620 Nm (457 ft-lb).
15.
Check and re-torque all wheel lug bolts as follows:
Wheel bolt
diameter
Torque (Nm)
Torque (ft-lb)
M16
320
236
M20
620
457
