6
mg1700
1. Insert the worm shaft into the cutter housing, the plastic end first.
2. Fit the cone on the metal end of worm shaft, and then fit the former. Make sure the notch of the
cone fit into the projection on the opening of cutter house.
3. fit the screw ring on the cutter housing by turning the screw ring clockewse until it is properly
fastened.
4. Fit the cutter housing on the motor unit. The lugs on the motor unit must fit precisely into the slots
on the cutter housing. Rotate the cutter housing anti-clockwise until hear a click. The cutter housing is
then locked in the position.
5. Place the tray on the upright part of the cutter housing.
6. The appliance is ready for making kebbe.
MAKING KEBBE:
Feed the prepared kebbe mixture through the kebbe maker. Cut the continuous hollow cylinder into the
desired lengths and user as required
◆
Kebbe is a traditional Middle Eastern dish made primarily of lamb and burgul wheat which are
minced together to form a paste the mixture is extruded through the kebbe maker and cut into short
lengths. The tubes can then be stuffed with a minced meat mixture, the ends pinched together and
then deep fried.
TEMP STOP/REVERSE
1. Keep pressing‘REV’ button when the appliance is in the mode of switch on, the appliance
temporarily stops working. Release the button, the appliance resumes working.
2. If the appliance is blocked, switch off the appliance first and press‘REV’ button, the worm shaft will
turn in the reverse direction. Then the appliance can renew its normal condition.
AUTO CUT OFF
This appliance is equipped with a thermostat system. This system will automatically cut off the supply
power in case of over heating. If this happens, unplug the appliance and let the appliance cool down for 60
minutes. After that the appliance can resume working.
ENG