Campbell UT10, Инструкция по эксплуатации

Страница: 12 / 70

UT10 Universal Tower
2
3.2 Outdoors
•
Locate suitable site (Section 4 , Siting and Exposure
(p. 3)
)
•
Prepare tower base (Section 7 , UT10 Tower Installation
(p. 7)
)
o
Raise tower (Section 7 , UT10 Tower Installation
(p. 7)
)
o
Install instrumentation enclosure (Section 8 , Preparing the Tower for
Use
(p. 16)
)
o
Install sensors (Section 8.5 , Sensor Installation
(p. 31)
)
3.3 Tools Required
Tools required to install and maintain a weather station are listed below.
3.3.1 Tools for Tower Installation
Shovel
Rake
Open end wrenches: 3/8 in, 7/16 in, 1/2 in, (2) 9/16 in
Magnetic compass
6 ft step ladder
Tape measure (12 ft and 20 ft)
Nut driver (3/8 in)
Level (24 to 36 in)
Pick or digging bar
Claw hammer
Materials for concrete form:
•
Hand Saw
•
(4) 2 in x 4 in x 8 ft piece of lumber
•
(8) 8 p double-head nails
•
(8) 16 p double-head nails
•
Concrete trowels
•
(2) 1 in to 1.5 in thick x 24 in boards to support base above forms
(optional)
•
Concrete
•
(2) 1 in x 2 in x 30 in piece of lumber for template frame
•
(2) 1 in x 2 in x 10 in piece of lumber for template frame
3.3.2 Tools for Instrumentation and Maintenance
Lock and key for enclosure
Magnetic declination angle (Section
8.5.18 , Wind Direction Sensor Orientation
(p. 50)
)
Magnetic compass
Straight bit screwdrivers (small, medium, large)
Phillips-head screwdrivers (small, medium)
Small diagonal side-cuts
Needle-nose pliers
Wire strippers
Pocket knife
Calculator
Multimeter
Electrical Tape