Campbell SC-USB, Инструкция по эксплуатации

Страница: 7 / 28

i
Table of Contents
PDF viewers: These page numbers refer to the printed version of this document. Use the
PDF reader bookmarks tab for links to specific sections.
1. Introduction ................................................................. 1
2. Technical Specifications ............................................ 2
2.1 USB Specifications .............................................................................. 2
2.2 CS I/O Port Specifications ................................................................... 2
2.3 General Specifications ......................................................................... 3
2.4 Ships With ............................................................................................ 3
3. Installation ................................................................... 3
3.1 Driver Installation ................................................................................ 3
3.2 Installing the SC-USB for the First Time ............................................. 5
3.3 Fixing a Failed Installation/Upgrading the Drivers .............................. 5
3.4 Uninstalling the SC-USB Drivers ...................................................... 11
3.5 Determining Which COM Port the SC-USB Has Been Assigned ..... 11
4. Set-up Modes – the SC_USB Programming
Utility ........................................................................ 13
4.1 Settings ............................................................................................... 13
4.1.1 Auto Detect (Automatic Baud Rate Detection)........................... 13
4.1.2 Selecting a Fixed Baud Rate ....................................................... 14
4.1.3 Enable All Comms Modes (Automatic Mode Detection) ........... 14
4.1.4 Enable CSDC Address 7 Mode ................................................... 14
4.1.5 Enable CSDC Address 8 Mode ................................................... 14
4.1.6 Enable SDC Comms Mode ......................................................... 15
4.1.7 Enable ME Comms Mode ........................................................... 15
4.1.8 Set ID .......................................................................................... 15
4.2 Operating System (OS) Downloads ................................................... 15
5. Using the SC-USB with Campbell Scientific
Software and Hardware .......................................... 15
5.1 LoggerNet EZSetup or Standard Setup .............................................. 15
5.2 Using the Device Configuration Utility ( DevConfig ) ......................... 16
5.2.1 Accessing DevConfig .................................................................. 16
5.2.2 Downloading a Datalogger OS ................................................... 16
5.3 Use with the DSP4 ............................................................................. 16
6. Troubleshooting........................................................ 17
6.1 Installation.......................................................................................... 17
6.2 Software Settings ............................................................................... 17
6.3 Electronic Interference ....................................................................... 18