Campbell RF451, Руководство по эксплуатации продукта, Страница: 40 / 48

4. Also on the RF451/RF452 sub-tab, set the Radio Operation Mode to Endpoint/Repeater. In
the Network ID box, type the same number set in the previous instruction Configuring the
RF451/RF452 radio connected to the computer (p. 32).
5. In the Frequency Key box, type the same number set in the previous instruction.
6. Apply to save your changes.
B.2.3 Adding the endpoint/repeater data logger to the
LoggerNet network
To add the repeater data logger to the LoggerNet network, follow the instructions found in
Setting up communications between the RF451/RF452 data logger and the computer (p. 29).
B.2.4 Adding endpoint data loggers to the network
1. In the
LoggerNet Standard Setup view (click Setup and then the View menu to ensure
you are in the Standard view), right-click on the repeater data logger in the Entire Network
pane on the left side of the window and select your data logger model such as CR6Series.
2. With the newly added data logger selected in the Entire Network pane, set the PakBus
Address to the address that was assigned to the endpoint data logger in Device
Configuration Utility .
3. Click Rename
to provide the data logger a descriptive name.
4. Apply to save your changes.
5. Repeat these steps for each endpoint data logger in the network.
B.2.5 Using additional communications methods
Using similar instructions, an RF451/RF452 data logger can be used in a system with additional
communications methods. For example, in the following image, the router RF451/RF452 data
logger communicates with
LoggerNet through Konect PakBus Routeran. The router RF451/RF452
data logger communicates with the endpoint RF451/RF452 data loggers over RF.
RF451/RF452 Spread Spectrum Radio 34