Campbell LS300G-EU, Руководство пользователя

Страница: 13 / 54

User Manual
3
4.3 Configure LS300G-EU
Quickstart describes configuring the LS300G-EU in serial server
mode. It may also be configured in Point-to-Point Protocol (PPP)
mode. For a description of the modes, see Section
5 , Overview
(p. 8)
.
For instructions on setting up the LS300G-EU in PPP mode, see
Section
7.5 , AceManager and Template Files
(p. 14)
, and Section 7.6 ,
Enabling PPP Mode
(p. 17)
.
The LS300G-EU setup for serial server mode may be done with the Device
Configuration Utility (DevConfig) version 2.09 or later. DevConfig may be
updated/downloaded at no charge at www.campbellsci.com/downloads . (The
LS300G-EU can also be set up in serial server mode using template files. See
Section
7.5 , AceManager and Template Files
(p. 14)
.)
Connect a serial cable (for example, USB-to-serial, between the PC and the 9-pin
serial port on the LS300G-EU.
Open DevConfig (either from the PC’s Start menu or by clicking the icon within
LoggerNet ) and select LS300 from the Cellular Modem group in the left panel.
In the lower left, select the correct Communication Port . Select the Baud Rate .
If unsure of the baud rate, click Find Baud Rate . For a new LS300G-EU, 115200
is the correct baud rate. Click Connect .
Click Load CSI Settings at the bottom of the screen.
On the Modem Status tab, note that the Modem Phone Number and Modem IP
Address are displayed, once the modem has authenticated on the network.
NOTE