Campbell HydroSense II Series, Руководство по эксплуатации продукта

Страница: 35 / 50

HS2 and HS2P
23
have replacement batteries available. The HydroSense II carry case has a spare
battery pack (holder only – batteries not included).
Configuration settings, stored data, and zones are stored in flash memory such
that they will be preserved during battery replacement.
11.1.1 Replacing the Battery Pack
The process to replace the battery pack is:
1.
If using the HS2P, follow the procedure provided in Section 11.2 ,
Removing Display from HS2P Pole
(p. 24)
.
2. Place the display face down on a clean dry surface.
3.
Remove the four (4) Phillips screws on the back of the display case with
the Phillips screwdriver provided in the carry case.
4. Carefully separate the back cover from the front cover, taking care to keep
the display face down (if the unit is turned face up, the battery holder
inside may fall out and damage the battery wires).
5.
Unclip the battery connector from the battery holder.
Although this connector looks similar to the terminals of a
9 V PP3 battery, it is not compatible with the 9 V battery.
Do not connect a 9 Vdc battery to the terminals, because it
can permanently damage the HydroSense II. This damage
is not covered under the warranty.
6. Connect the spare battery holder to the battery connector.
7. Carefully replace the back cover of the display and replace the four
screws.
8. Turn over the display and hold the button for 3 seconds to activate.
9. If using the HS2P, reinstall the display onto the pole.
CAUTION