CRVW3 3-Channel Vibrating-Wire Datalogger
78
When connecting the RF451 base radio directly to the
LoggerNet
computer,
connect the USB cable to the
USB
port of the RF451, and configure it with
DevConfig
as instructed in the RF451 manual. See Section
Connection to the Base Station
(p. 80)
, for more information.
Base Station Design for RF451 Radio
(p. 68)
, the CRVW3 itself is rarely used as the base radio station in an
RF451 Network. However, to use that configuration, ensure that the
Radio
Operation Mode
setting in the
Radio
tab of
DevConfig
is set to
Point to
MultiPoint Master
. Also set the
Is Router
setting located on the
PakBus
tab
of the
Settings Editor
tab in
DevConfig
to
True
.
Use a temporary CRVW3 station and
LoggerNet
to validate the operation of
your deployed RF451 base station before leaving the site (see Section
(p. 76)
, above).
10.5.2 Base Station on the RF407 Network
The RF407 radio should typically be used as the main component of the base
station in an RF407 network. Refer to the RF407 manual for details regarding
the setup and configuration of the RF407 radio portion of the base station.
s.campbellsci.com/documents/us/manuals/rf407-series.pdf
The base radio should connect to
LoggerNet
either through a USB cable or via
a telemetry device such as the NL201, NL240, or RV50. When using telemetry
options, a serial cable is typically connected from the RS-232 port of the
RF407 radio to the RS-232 port of the telemetry device. The telemetry device
should usually be configured as a serial server. When using Campbell
Scientific telemetry devices, the device can be configured as a PakBus router
instead. Consult both the RF407 manual and the manual for your specific
telemetry device for details about how to connect and configure these devices
to work together. Once the base station is enabled via telemetry,
LoggerNet
will usually use TCP/IP to communicate with the base station.
s.campbellsci.com/documents/us/manuals/nl200.pdf
s.campbellsci.com/documents/us/manuals/nl240.pdf
s.campbellsci.com/documents/us/manuals/rv50.pdf
When connecting the RF407 base radio directly to the
LoggerNet
computer,
connect the USB cable to the
USB
port of the RF407, and configure it with
DevConfig
as instructed in the RF407 manual. See Section
Connection to the Base Station
(p. 80)
, for more information.
Base Station Design for RF407 Radio
(p. 70)
, the CRVW3 itself is rarely used as the base radio station in an
RF407 Network. However, to use that configuration, ensure that the
Is Router
setting located on the
PakBus
tab of the
Settings Editor
tab in
DevConfig
is
set to
True.
Serial Cable
Internet Cloud
LoggerNet
Computer
NL201
RF407
Содержание CRVW3
