CRVW3 3-Channel Vibrating-Wire Datalogger
51
FIGURE 8-18. CRVW3 Latch Closure and Lock Location
Screws are provided by the enclosure manufacturer to maximize water
protection. Install these screws into each of the four corners of the enclosure to
ensure the maximum protective seal between the lid and the main section of the
enclosure.
During maintenance, you should wipe off any water from the outside of the
enclosure before opening the enclosure lid.
8.3 On-site Manual Data Collection
A technician located at a deployment site can use a USB cable to manually
collect measured data from a CRVW3 using a Windows computer (laptop PC)
and
LoggerNet
,
PC400
, or
PC200W
software.
Manual Data Collection at the CRVW3 Site
(p. 92)
, for
details about this data collection process.
9. Radio Networks
Any deployment of radio-based CRVW3 devices involves the installation and
operation of a
radio network
. That radio network can be simple or complex,
depending on how it is designed and implemented. Implementation decisions
are driven by the measurement requirements and geographic constraints of the
desired data collection system.
When creating CRVW3 radio networks, a
base radio station
is always
required. The base station functions as a gateway device enabling non-radio
communications to enter or exit the radio network. The communications
pathway provided by the base radio is critical for
LoggerNet
or other software
or hardware to communicate with a network of CRVW3 devices.
Содержание CRVW3
