Installation Manual
9
7.3 Leg Base of a CM110, CM115, CM120 Tripod
The leg mount option is intended for attaching an ENC10/12, ENC12/14, or
ENC14/16 enclosure to the leg base of a CM110, CM115, or CM120 tripod. An
enclosure ordered with this option will be shipped with a bracket attached to each
side of the enclosure and a u-bolt bracket. A #19124 bracket must also be attached
to the tripod (see Figure 4-7).
(1) For some tripods, the #19124 bracket may not be pre-installed
on the tripod at the factory. In this situation, the #19124 bracket and
mounting hardware will be shipped with the tripod and will need to
be installed as shown in Figure 7-7.
(2) An ENC16/18 cannot be mounted to the leg base.
Attach the enclosure to the leg base as follows:
1.
Place the flange of the tripod’s bracket into a notch in one of the enclosure’s
bracket (see Figures 7-7, 7-8, and 7-10).
2.
Attach the u-bolt bracket on the other enclosure bracket (see Figure 7-9).
3.
Use the furnished 70 mm centre u-bolt to secure the enclosure bracket to a
tripod leg (see Figures 7-9 and 7-10).
4.
Route the 14 AWG wire from the brass tripod grounding clamp to the
enclosure grounding lug. Strip one inch of insulation from each end of the
wire and insert the end of the wire into the grounding lugs and tighten.
Figure 7-7. The #19124 bracket attached to a CM110 tripod.
NOTES
Flange
