![background image](http://html1.mh-extra.com/html/campbell-hausfeld/in470300av/in470300av_product-manual_490012002.webp)
2
www.chpower.com
Operating Instructions and Parts Manual
Frequently Asked Questions
how do I start my pressure washer?
1 .
Make sure you have gas and oil in the engine . The engine does not come with oil .
2 .
Turn the water on, then squeeze the trigger on the gun to make sure the water will flow smoothly out of the tip .
3 .
Put the engine throttle control fully to the left, in the “Fast/Start” position . Set the shut off switch to “ON .”
4 .
Set the choke fully to the left . Set the fuel valve lever fully to the right in the “ON” position .
5 .
Pull the trigger (to relieve any back pressure in the pump) while pulling the starter cord .
what type of oil do I use?
Engine: The engine DOES NOT COME FILLED WITH OIL . See Page 10 for engine oil types and quantities .
Pump: The pump comes filled with the correct amount of oil and should not need changing or filling . Refer to Pages 9 and
10 of this manual for oil changing instructions, oil types and quantities .
why don’t I have any water pressure?
•
Is the water hose attached to the pressure washer?
•
Is the water turned on?
•
Check for any kinks, leaks, or blockage in the hoses, fittings, or the nozzle.
•
Is the quick connect tip in place? (See Page 5 and 6).
•
Is the inlet filter screen free of debris? Check and remove debris if needed.
how do I get high pressure?
•
Use any color tip except black. The black tip is only used for low pressure detergent application.
how do I get the soap suction to work?
1 . Connect the clear plastic chemical suction tube to the plastic hose barb on pump, insert the other end into your
detergent .
2 . Install the black spray tip to apply low pressure detergent .
why doesn’t the pressure washer apply detergents with high pressure?
Detergents “bounce” off cleaning surfaces as fast as they are applied . The pressure washer’s features allow for a detergent
to be drawn while in low pressure mode only . By applying detergent at low pressure, the effect of “bouncing” is reduced .
Also, detergents are only effective when time is allowed for them to work on the surface of whatever is being cleaned . After
applying the detergent, wait 1-3 minutes while it works, and then proceed to rinse the surface with high pressure .
what maintenance do I need to perform on my pressure washer?
1 .
After turning off the pressure washer and the water, depressurize the hose by triggering the gun .
2 .
Remove the garden hose and high pressure hose from the pump .
3 .
Pull the start rope slowly five times to purge water from the pump . This will help protect the pump from damage .
4 .
Do not store your pressure washer in an area where the temperature will drop below 32° F .
5 .
Follow proper storage and winterizing instructions found on pages 8 and 9 .
what do I do if I’m missing a part?
Call Campbell Hausfeld at 1-800-330-0712 and we will promptly replace your missing parts .
DO NOt returN the PreSSure
WASher tO the retAIler!
where can I buy accessories for my pressure washer?
•
If you can’t find accessories at the store where you purchased your pressure washer, call Campbell Hausfeld at
1-800-330-0712 or visit our website at www .chpower .com .
who do I call if I have questions or problems?
Call Campbell hausfeld at 1-800-330-0712 (u.S.A.)