FT-193 Caterina Fountain in Basin
Assembly Instructions
Professional installation is recommended for this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 3000 lbs with an
approximate 47 sq. ft. footprint (approximately 83" Diam.).
Step 1 - Place the fiberglass basin where the fountain is to be installed.
1a - Be sure to check that each part is level and centered during the assembly of this
fountain.
Step 2 - Place the stopper approximately 3 ft. from the pump.
Step 3 - Feed the pump cords through the hole in the basin.
Step 4 - To ensure a level installation, make sure that you run the remaining cord through the
channel in the bottom of the basin.
Step 5 - Press stopper firmly and evenly into the hole of basin.
Step 6 - Loosely wrap cord up in the center of the basin.
FGB-2030 (130 lbs)
72"W x 11.75"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 7 - Place the fountain base (FT-193F) over the pump and the cord.
Step 8 - Place the large pedestal (FT-193E) on top of the base.
FT-193F (91 lbs)
18"W x 11"H
FT-193E (96 lbs)
15.25"W x 17"H
