ERGOPOWER CONTROL LEVERS - Rev. 00/ 07-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
9
• Move the control to the smallest sprocket position (Fig. 12).
The Ergopower Ultra-Shift controls allow you to upshift up
to five cogs in a single lever throw.
• Lift up the hood and push the end of the 680 mm long, 4.1
mm diameter housing into the hole provided (Fig. 11).
Slightly bend the cable (for the first 5 – 10 mm) (Fig. 11) to
facilitate insertion of the same into the housing.
Insert the rear derailleur cable (length 2,000 mm - ø 1.2 mm)
into the bottom of the control (B – Fig. 13).
C
• Run the cable through the right hand opening (D - Fig. 15) of
the cable guide plate located under the bottom bracket box;
insert the cable into the support on the sheath.
D
• On the 330 mm - ø 4.1 mm sheath apply a sheath terminal, run the cable and insert it into the specific right hand rear sheath support (A - Fig. 16).
• Apply a sheath terminal to the other end of the sheath and secure the cable onto the rear derailleur (see the technical manual chapter on the
rear derailleur).
B
A
WARNING!
Before cutting out the housing, please be careful to make
sure that the chosen length is suitable for the size of your
frame. An insufficient length may cause too straight curves
and will prevent the transmission from functioning properly.
• Cut the housing (on the frame side) so that it reaches the
metal cable stop on the frame (C - Fig. 14).
• After cutting the housing at the suitable length, fit a
housing end and insert the housing in the Downtube barrel
adjuster (C - Fig. 14) on the frame.
4.1.1 - REAR DERAILLEUR CABLE AND HOUSINGS
12
11
14
13
15
16
WARNING
Use only “maximum smoothness” cables and sheaths, and end caps like those shown in Fig.16.
B
