ERGOPOWER CONTROL LEVERS - Rev. 00/ 07-2022
CAMPAGNOLO COMPONENTS - TECHNICAL MANUAL
12
• Insert the brake cable (length 1,600 mm - ø 1.6 mm) into the bushing on the right hand
Ergopower™ control brake lever, ensuring that the cable stop head fits into its seat (Fig.
24).
• Ergopower™ control levers do not require a brake housing end.
• Depending on your frame, it may be necessary to cut the rear brake housing (1,250 mm
long - diameter ø 4,9 mm) and install a housing lead end (diameter ø 6 mm).
• Insert the sheath (without the sheath terminal) into the control and into the brake she-
ath stop and secure the cable to the brake (see the “brakes” section).
• Insert the brake cable (length 800 mm - ø 1.6 mm) into the bushing on the left hand
Ergopower™ control brake lever, ensuring that the cable stop head fits into its seat (Fig.
24).
• Ergopower™ control levers do not require a brake housing end.
• Fold back the hood.
• Tape the handlebar of the Ergopower™ control body.
• Refit the support hood in position.
• Depending on the frame you have, you may need to cut the front brake sheath (length 580 mm - ø 4.9 mm) and install sheath terminals (ø 6 mm).
• Insert the sheath (without the sheath terminal) into the control and into the brake sheath stop and secure the cable to the brake (see the “bra-
kes” section).
4.2.1 - REAR BRAKE CABLE AND SHEATH
4.2.1 - FRONT BRAKE CABLE AND SHEATH
4.3 - TAPING THE HANDLEBAR
WARNING!
Before using your Ergopower
™
system on public roads, ride in an open, traffic free area to become familiar with the Ergopower’s function and
operation. Failure to do so could result in an accident, personal injury or death.
4.2 - BRAKE CABLE AND SHEATH (in the case of a hydraulic brake, refer to the
Technical Manual: Disc brake hydraulic system)
24
