CAMPAGNOLA KRONOS, Руководство по эксплуатации и обслуживанию

Страница: 37 / 332

Page 36
Use and maintenance manual – Translation of
original Instruction. : 01 date 15/12/2021
6.3 Periodic maintenance table
MAINTENANCE ROUTINE EXTRAORDINARY
Bef
or
e us
e
Ev
er
y 2 w
or
king
h
our
s
Ev
er
y day
Ev
er
y w
eek
Ev
er
y 90 d
ay
s
At
th
e e
nd o
f eac
h
w
or
ki
ng s
eas
on /
at
leas
t onc
e a
y
ear
Check chain lubrication.
X X X
Check the condition and tension of the chain. X X X X
Check the condition of the bar. X X
Check the efficiency of the safety catches and protections. X X
Check and top up the oil X X X
Remove cutting residues. X X
Check the chain pinion for wear.
X
Overhaul to be carried out at a Manufacturer’s Authorised Assistance
Centre.
X
7 DISMANTLING THE MACHINE WHEN NO LONGER USED
7.1 Disposal of exhaust materials
After having been installed and during use, the machine does not cause any environmental pollution. However,
throughout its working life, some types of residual waste or exhaust materials, such as the lubricants for the
mechanical components, are being produced in certain maintenance situations.
There are specific regulations in every Country as for the disposal of these materials and the environment protec-
tion. The Customer is required to be knowledgeable in the Laws in force in his own Country and to operate only
while complying with these regulations, according to the indications in the product technical charts, which may
be obtained from the Manufacturer.
The Laws in force about the disposal of mineral oils or greases used for the lubrication / maintenance operations
must be followed.
More information about the disposal of oils and other substances can be found in the safety chart of the sub-
stances.
The steps employed in the disposal of toxic waste including the collecting, transporting, processing (transfor-
mation for recycling), as well as the deposit and the dumping onto the ground are all usual activities of common
interest and are subject to the following general principles:
a) Any risks of injuries or dangers for the health and safety of any individual and of the community have
to be avoided.
b) Compliance with any and all hygienic-sanitary requirement and avoidance of any air, water, ground
and underground pollution have to be guaranteed.
Compliance with efficient and economical principles in order to save and recycle energy and materials shall be
promoted.
Plate upper angle Plate side angle
Cutting angle of the up-
per plate
Depth calliper
Parallel