Page 15
MAINTENANCE AND ADVICE
7
To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove dust, use
a soft cloth. To remove a stain, use a damp cloth.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR HEATER AS
THIS MAY DETERIORATE THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN, AND ONLY AFTER THE
HEATER HAS BEEN DISCONNECTED.
Operation and maintenance tips
Your CONVECTAIR heater will become hot when in use. Caution is advised when
young children are present.
Do not insert small objects in the heater, this could cause an electrical short circuit, fire
or damage to the inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short
circuits, fire or injuries to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not
due to a manufacturing defect. This is caused by surrounding air, which may contain
smoke or dust, being heated and circulated through the heater.
Prevention : it is suggested that surfaces be frequently cleaned especially with units
installed in locations where cigarette smoke is present or in the kitchen.
Never use this heater during construction work or other activities that gene-
rate a lot of dust.
Note : The first time your CONVECTAIR heater is used, a light smoke could be re-
leased. This is normal and should disappear after about 2 to 3 minutes.
RE-ALIGNING SETTINGS (thermostat/thermometer)
RE-INITIALIZING THE THERMOSTAT
Factory settings can be reinstated by simultaneously pressing
the 3 keys
and the Temperature adjustment
knob for 10 seconds while the thermostat is in standby
mode.
(This operation can only be carried out while the heater is in standby mode)
Exceptionally, under certain conditions, there may be a difference between the figure
displayed by your screen and that provided by the thermometer. Should this occur, you
can re-align both settings.
This adjustment is only possible when your appliance is set to between 17 and 22°C.
All doors and windows must be closed.
Let the room temperature stabilize (at least 6 hours) and avoid coming into and going out of
the room as much as possible.
The control thermometer must be placed in the centre of the room at a height of 1.20 metres.
Do not place it on furniture.
After 6 hours, record the difference between the temperature shown by your thermometer and
that displayed by the appliance.
Simultaneously press both
keys and the knurled setting button
for 10 seconds.
Turn the knurled setting button
to reset the temperature as indicated by your thermometer.
Correction up to +/- 2°C
E.g. 20.5° on the thermometer, 19.5° on the
thermostat screen. Use the knurled setting button
to correct the setting by increasing it by +1° (20.5-19.5).
13
Press 2 times on the key
to validate your choice.
