Operation and maintenance instructions
Series PRE proportional pressure regulator
Analog /preset version
5000024670
Ver. 01
31
15.
Limitations on use
•
Never exceed the technical specifications stated in the paragraph "General characteristics"
and the Camozzi general catalogue.
•
With the exception of specific intended applications, do not use the product in environments
where there is the risk of direct contact with corrosive gas, chemical products, salt water,
water or steam.
•
If possible, do not install the device:
o
in closed and small spaces
o
exposed to direct sunlight (if necessary provide a shield)
o
near heat sources or in areas subject to sudden changes in temperature
o
near power on parts with no proper insulation
o
near conductors or electrical devices with high alternate or impulsive currents
(danger of parasitic currents);
o
near sources of high intensity electromagnetic waves (antennas) (danger of parasitic
currents and / or arcing of electric arcs).
16.
Maintenance
•
Check all conditions to prevent the inadvertent release of parts, and disconnect the power
supply to enable the discharge of residual pressure from the system before performing work.
•
Discharge all pressure from the system and the actuator itself.
•
Check whether it is possible to have the product serviced at a technical assistance centre.
•
Never disassemble units when pressurized.
•
Shut off all pneumatic, hydraulic and electric supplies before maintenance.
17.
Environmental notes
•
At the end of the product's life cycle, separate the relative materials to enable recycling.
•
Observe all current standards in the country of use governing waste disposal.
•
The product and relative parts all comply with the standards ROHS and REACH.
