10
-Auto Power off:
-Motion detection:
-Flip picture:
-Image mirroring:
-Light Frequency:
-Video System:
-Status LED:
-Card formatting:
-Factory setting
-Firmware:
Select the Auto off function: Off, 60 Sec., 120 Sec. or 300 Sec.
Off, low, medium or high
normal or 180° flipped
normal or mirrored
50/60Hz - Before you start recording indoor, choose the
correct frequency:
Europe, Asia and Australia: 50Hz
America: 60Hz
Japan: Depending on the area 50 or 60Hz
NTSC or PAL
On or Off of the front LEDs
Choice between Slot 1 or Slot 2 (All recorded data will be
deleted!)
Resetting the camera
Information about current firmware and update
Please note that some functions are only available after a firmware-/ software update.
Using the DiveBox and different mounts
Please make sure that the lens of the cam and also the lens-protection of the inner side of the
box is clean.
Insert the cam. Please check carefully that the fastener of the box is properly locked. The
cam can still be operated though the buttons.
When using the bike or helmet mount, please pay attention that the adjusting screws are fixed
tightly.
Mounts that are glued on must have a clean surface.
Photo/ Video recording
Right after switching on the Cam it is possible
to take pictures or videos by pressing the
’record’ button.
Press the button again to stop the recording.
Never remove the SD-card or the battery
during the data-saving. (shown with a rotating
circle in the display).
