8
Brine Master
®
English
Startup
3)
Without powering on the pump, gravity fill the Brine Master®
hopper by opening the “Fresh Water” port valve (#4). Once
the water is covering the jet nozzles inside the brining hopper,
close the valve (#4) to stop the fresh water
filling process. If the pump is powered on
during this initial start-up filling process,
the high-pressure jets will cause water
splash/spray from the hopper.
4)
Load hopper with the first batch of salt. Always load the salt
slowly to avoid water splashing. Load towards the opposite
end of the hopper overflow, so that the salt does not obstruct
the overflow screen. For best results,
make sure the salt is heaped above the
water. Once you start the pump, the water
flow will distribute the salt down and to
the sides of the hopper.
2)
Place discharge valve (#1) to “Discharge to
Brining Hopper” position and place the suction
valve (#2) to “Suction from Fresh Water” posi-
tion.
1)
Connect fresh water supply hose to
the “Fresh Water” port valve (#4), and
the brine to storage tank hose to the
“Discharge” port (#5) and plug the power
cord into the power source.
OPERATION
