PM 1000289 000 01
Device handbook SIRAX BT5200
22/32
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
ON
O/P1
O/P2
COM
O/P 2
O/P 2
*
O/P 2
*
O/P 2
*
O/P 2
*
O/P 2
Pressing the “ Down” key will enter the “New/Change Start value of the Output 2 edit” mode.
Pressing “ Up” key will confirm the present value as Start value of the Output 2 and advance to the Elbow
value of Output selection (section 7.1.6.2.3) or exit setup menu.
New / Change Start value of the Output 2
(*Denotes that digit will be flashing).
Pressing the “ Down” key will not affect the value of first digit, it is always 0.
Pressing the “ Up” key will advance the operation to the next digit and set the first digit, in every case to
“0”.
Enter New / Change Start value of the Output 2, first digit entered, prompting for second digit. (*Denotes that
digit will be flashing).
Pressing the “ Down” key will scroll the value of the second digit from 0 through to 2, the value will wrap
from 2 round to 0,if first digit is 0.
Pressing the “ Up” key will advance the operation to the next digit and set the second digit, in this case to
“1”.
Enter New / Change Start value of the Output 2, second digit entered, prompting for third digit. (*Denotes that
digit will be flashing).
Pressing the “ Down” key will scroll the value of the third digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “ Up” key will advance the operation to the next digit and set the third digit, in this case to
“5”.
Enter New / Change Start value of the Output 2, third digit entered, prompting for fourth digit. (* denotes that
digit will be flashing).
Pressing the “ Down” key will scroll the value of the fourth digit from 0 through to 9, the value will wrap
from 9 round to 0.
Pressing the “ Up” key will advance the operation to the “New / Changed Elbow value of the Output 2”
and set the fourth digit, in this case to “0”.
New/changed Start value of the Output 2 confirmed
Pressing the “ Down” key will re-enter to the “New / Change Start value of the Output 2”.
Pressing the “ Up” key will confirm New Start value of the Output 2 and advance to the Elbow value of
Output selection (section 7.1.6.2.3) or exit setup menu.
7.1.6.2.2 Start value of output 2
This screen allows the user to set the Start value of Output 2 (considerd as DC Voltage). Start value of Output can be set up to 20% of set End
value of Output.
