36
6. Mounting
The SINEAX DME 406 can be mounted either on a top-hat
rail or directly onto a wall or mounting surface.
Note “Environmental conditions” in Section
“5. Technical data” when determining the place
of installation!
6.1 1 Mounting on top-hat rails
Simply clip the device onto the top-hat rail (EN 50 022) (see
Fig. 4).
Fig. 4. Mounting on top-hat rail 35
×
15 or 35
×
7.5 mm.
6.2 Wall mounting
While pressing the latch (4) in the base of the device (Fig. 5,
left) pull out the isolating amplifi er securing brackets (1). To
return the brackets to their original positions, the latch (5) in
the base of the device has to be depressed before applying
pressure to the securing brackets (1) (see Fig. 5, right).
(4) Latch for pulling the screw hole
brackets
out
(5) Latch for pushing the screw hole
brackets
in.
(1)
(2)
(3)
(2)
(4)
(1)
(1)
(1)
(5)
Fig. 5. Rear of device.
(1) Screw hole brackets
(2) Top-hat rail clips
(3) Rubber buffers
Drill 2 holes in the wall or panel as shown in the drilling
pattern (Fig. 6). Now secure the power pack to the wall or
panel using two 4 mm diameter screws.
165
Fig. 6. Drilling plan.
Содержание SINEAX DME 406
Страница 2: ...2 ...
