CAMERA LINK Q-12A65, Руководство по эксплуатации и инструкция пользователя

Страница: 60 / 66

OPERATING AND USER MANUAL QUARTZ SERIES
61
Service and maintenance 10.
Camera status commands 10.1
Built-in test 10.1.1.
The built-in test command returns the basic status of the camera.
Command format: BIT?
Return Message: x
Where x indicates the addition of the actual error codes:
CODE DESCRIPTION
0 All tests are passed
1 FPGA boot failed
2 FPGA not running
4 Configuration data corrupt
8 Setting data corrupt
128 Output look-up table data corrupt
256 Sensor data alignment error
Error diagnosis 10.1.2.
Since the communication protocol does not check the message content, the error result of a command
must be obtained by the ERR? query command.
Command format: ERR?
Return Message: x
The ERR? command returns a single integer value x, the error code of the last executed command
(The ERR? command itself when executed successfully does not effect the last error result).
A list of all possible error values and the cause of the error code are shown below:
CODE CAUSE
0 Last command executed with success
1 Unknown command received
2 Parameter expected after command keyword
3 Invalid parameter syntax in last command
4 Too many parameters in last command
5 Not enough parameters in last command
7 Invalid parameter values in last command
100 LC command failed, no power-up defaults found. This indicates an internal NVRAM failure.
101 FD command failed, no valid factory defaults found. This indicates an internal NVRAM failure.
120 LUTBGN operation failed: LUT transactions already pending
121 Trying to add LUT elements or end LUT, but not opened
122 LUTEND, while too few elements were received
123 Adding more elements than allowed
NOTE: If no invalid commands or command parameter values are sent to the camera it is not