Cameo ZENIT W600 D SMD, Руководство пользователя

Страница: 16 / 180

MFMF DMXDMXDEUTSCHFRANCAISESPAÑOLENGLISHITALIANOPOLSKIITALIANOPOLSKIESPAÑOLFRANCAISDEUTSCHENGLISH CONFIGURING DMX MODE (DMX MODE) Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item DMX Mode (observe arrow) and confirm with ENTER. In the submenu, you can now select the desired DMX mode with UP and DOWN. Confirm your selection with ENTER. Tables with the channel assignments can be found in these instructions under DMX CONTROL. CONFIGURE STANDALONE MODE Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item Stand Alone (observe arrow) and confirm with ENTER. In the submenu, you can now select the stand-alone modes Static , Pixel and the timer function Timer with UP and DOWN. Confirm your selection with ENTER. STATIC MODE (STATIC) Static mode allows the Dimmer and Strobe functions to be adjusted directly on the device with values between 000 to 255, similar to a DMX control unit. In this way, an individual scene can be created without an additional DMX controller. Select Static mode as per the procedure previously described in SETTING STAND ALONE MODE and confirm with ENTER. Now use UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER. The display will now show a three-digit number field, and you can use UP and DOWN to configure the desired value between 000 and 255. Confirm with ENTER. PIXEL MODE (Pixels) Pixel mode allows you to set dimmers, patterns and speed directly on the device with values from 000 to 255. Dynamic patterns can be found from value 006 to 098 and static patterns from 128 to 234. The speed of the dynamic patterns is set from 006 (fast) to 126 (slow) and in the reverse direction from 128 (slow) to 255 (fast) (000 – 005 and 127 = stop). Select Pixel mode as per the procedure previously described in SETTING STAND ALONE MODE and confirm with ENTER. Now use UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER. The display will now show a three-digit number field, and you can use UP and DOWN to configure the desired value between 000 and 255. Confirm with ENTER. TIMER FUNCTION (Timer) The timer function allows the standalone mode Static to be timer controlled in such a way that the fade-in time can be set from 0 to 60 minutes, the dwell time from 1 to 24 hours and the fade--out time from 0 to 60 minutes. Time control starts immediately after activating the timer function in the previously activated standalone mode and remains active even if the spotlight is switched off and restarted. Select Timer by means of the procedure described above under CONFIGURE STANDALONE MODE and confirm with ENTER. Now select “Fade In”, “Dwell Time” or “Fade Out” for the individual set-tings (observe arrow) and confirm with ENTER. The display will show a three-digit number field in each case. Use UP and DOWN to set the value as required from 000 to 060 or 001 to 024. Confirm by pressing ENTER again. Once all settings have been configured as required, activate the timer function by selecting the submenu item “Timer On/Off” using UP and DOWN, confirm with ENTER, select “On” and confirm again with ENTER (to deactivate the timer function, please select “Off” and confirm). Please note: The timer function is suitable for use in master/slave mode via cable and W-D-MX™.