Cameo ZENIT W600 D SMD, Руководство пользователя

Страница: 15 / 180

15
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
2. Pair a group of W-DMX™ devices to create a DMX universe with them. First decouple all
devices that should form the group (Settings -> Wireless Setting -> Receive Reset). Then
select a CLZW600 with a DMX controller via DMX cable and select "Transmit" in the settings
(Settings -> Wireless Setting -> Operating Mode -> Transmit). Select "Receive" in the settings
of the W-DMX™ device that you want to control via W-DMX™ (Settings -> Wireless Setting ->
Operating Mode -> Receive), and pair it by selecting "Link" in the settings of the DMX cable
controlled CLZW600, then confirm your selection (Settings -> Wireless Setting -> Link -> Link).
Pairing is then completed automatically.
3. It is also possible to create a connected group of W-DMX™ devices via W-DMX™, and operate
them in master/slave mode. First decouple all devices that should form the group (Settings
-> Wireless Setting -> Receive Reset). In the settings (Settings -> Wireless Setting -> Ope-
rating Mode) of the master unit select "Transmit", and in the settings of the slave units select
"Receive". On the master unit select "Link" (Settings -> Wireless Setting -> Link -> Link) and
confirm your selection by pressing ENTER. Pairing of the devices is then completed automati-
cally. Select standalone mode in the master unit and use this to control the slave units (same
model).
W-DMX™ STATUS
G3 G4S
W-DMX™
deactivated
W-DMX™
activated as
receiver,
not paired
W-DMX™
activated as
receiver and is
paired to device,
Transmitter is
switched off or
out of range
W-DMX
activated and is
paired to device,
no DMX signal
W-DMX™
activated as
receiver and is
paired to device,
DMX signal is
present
W-DMX™ and
transmission
mode G3 is
enabled
Up arrow =
Send operation
Down arrow
= Receive
operation
Arrow flashes=
Pairing process
Flashing stops =
Paired
W-DMX™ and
transmission
mode G4S
activated
Up arrow =
Send operation
Down arrow
= Receive
operation
Arrow flashes=
Pairing process
Flashing stops =
Paired
SETTING DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
DMX Address (observe arrow) and confirm with ENTER. The display will show a three-digit num-
ber field and you can use the UP and DOWN controls to configure the desired DMX start address.
Confirm the entry with ENTER and press MODE to return to the main display (in the example,
"DMX address 001").
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
DMX Address
001
001
5xx
-