18
NETWORK SETTINGS (Network Settings)
Use the UP and DOWN buttons to select the “Network Settings” menu item and confirm by pressing ENTER. The required sub-menu can be selected
by using the UP and DOWN buttons, confirm with ENTER and adjust the settings as needed.
Network Settings
Sub-menu items and explanations:
Network Settings
IP Address
Number block 1
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
address using UP and DOWN, confirm with ENTER
Number block 2
000 - 255
Number block 3
000 - 255
Number block 4
000 - 255
SubNet Mask
Number block 1
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
number using UP and DOWN, confirm with ENTER
Number block 2
000 - 255
Number block 3
000 - 255
Number block 4
000 - 255
ArtNet Universe
Number block 1
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
universe using UP and DOWN, confirm with ENTER
Number block 2
00 - 15
Number block 3
00 - 15
For example:
Universe 1
000
00
00
Universe 17
000
01
00
SYSTEM SETTINGS AND INFORMATION (Settings & Info)
Use the UP and DOWN buttons to select the “Settings & Info” menu item and confirm by pressing ENTER. The required sub-menu can be selected by
using the UP and DOWN buttons, confirm with ENTER and adjust the settings as needed and read the relevant information.
Settings & Info
Sub-menu items and explanations:
Settings & Info
Display on/off
Display lighting
on
permanently on
confirm with ENTER
off
deactivation after approx. 20
seconds of inactivity
Signal Interrupt
operation status in
case of signal interruption
Hold
last command is held
confirm with ENTER
Auto
activates the auto program
Blackout
activates Blackout
Software Version
Firmware Version
Firmware x
Display with ENTER
Operation Hours
Operating time in hours and minutes
after switching on
xx:xx
Display with ENTER
Test
Testing all LEDs
on
Starting test sequences
confirm with ENTER
off
Stopping test sequences
Factory Reset
Reset to factory setting
on
Starting reset operation
confirm with ENTER
off
Do not perform the reset operation
Esc
When exiting the menu level
confirm with ENTER
DE
HINWEIS
Wenige Sekunden nachdem der Scheinwerfer korrekt am Stromnetz angeschlossen wird, ist er betriebsbereit und startet in der Betriebsart, die zuvor
angewählt war. Beim Start wird kurz die Firmware Version im Display angezeigt.
BETRIEBSART EINSTELLEN (Operation Mode)
Wählen Sie mit Hilfe der Tasten UP und DOWN den Menüpunkt „Operation Mode“ aus und bestätigen mit ENTER. Die gewünschte Betriebsart wählen
Sie nun wiederum mit Hilfe der Tasten UP und DOWN aus und bestätigen mit ENTER. Zum Verlassen des Untermenüs auf MODE drücken.
Betriebsarten: Manual Mode, DMX Mode, Art-Net Mode, Kling-Net Mode, Slave Mode, Auto Mode.
Operation Mode
Untermenüpunkte und Erläuterungen:
