Cameo CFP-200, Руководство оператора

Страница: 13 / 36

＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞＞
| Aidite 09
Chapter 2 | Safety Maintenance and Precautions
The furnace shall burn without load for three times before officially burning teeth models.
As the porcelain furnace works for the first time, it is recommended to run for 3
hours in standby mode (the
tray is lowered to the lowest position) to remove the moisture in the furnace.
Inflammable and volatile substances are strictly prohibited to place around the furnace. Do not place
inflammables next to it, and ensure ventilation and heat dissipation at the same time.
When the furnace needs to be moved, firstly cut off the power and then move it gently, to avoid collision
and damage.
When “abnormal vacuum” is prompted, please immediately check if the vacuum pipeline is leaked or
plugged and if the solenoid valve is damaged.
2.4 Cleaning
When cleaning, do not clean the upper cover of the furnace with the wet cloth, to avoid water dripping,
short circuit or furnace damage.
When the fault light is on or the buzzer gives an alarm, the fault shall be eliminated by professional
maintenance personnel.
If the fuse is blown out, take it out of the fuse holder of the furnace terminal board, replace it with a spare
fuse and tighten the fuse holder.
Note: if the installed fuse is not originally supplied, please confirm the specification of the fuse before
installation to avoid safety accidents.
There is a fan behind the furnace to dissipate heat for the furnace. When the furnace runs, do not block
the fan cooling port or the upper cover of the furnace.
The furnace shall not be overhauled during operation. If the upper cover of the furnace is opened, ensure
that the furnace is powered off, to avoid electric shock.
No junk can be placed on the upper cover of the furnace to avoid fire.