Badly connected or corroded battery terminals can cause intermittent problems, check battery terminals, clean
and connect again.
Check the distance between the remote control and the caravan is not more than 5metres. If there is no signal
between the remote control handset and the control unit, the manoeuvring system will not function at all and
the green LED on handset is blinking.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote control handset and control unit. If there is no good communication between
the control unit and remote control handset, the manoeuvring system will not function and the green LED on
remote control handset is blinking.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the manoeuvring system by switching off the manoeuvring system via the isolation switch and the
remote control handset for at least 15 seconds and then turn them on again.
Roller will not turn, spindle rotates freely:
The motor or gear is broken, please contact your
Camec Elite Pro
®
supplier.
In case of any doubt, please call your
Camec Elite Pro
®
supplier.
Ref:
ELITE
PRO
EM30
5
-
0814
-Rev.A.
CAMEC
ELITE
PRO
EM30
5
1
8
“More information https://www.caravansplus.com.au"