CAME LVC/01, Руководство по программированию, Страница: 9 / 16

M
PROG PROG
1 1
>3’’
1
2 2
1 P.E 2 P.E
beep beep
beep beep
4
beep beep
M
PROG PROG
5 5
<1’’
beep beep
3 3
M
PROG PROG
6 6
>3’’
1
G G
1 P.E 2 P.E
Page
9
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
9
- Manual
FA01725-EN
- 03/2022 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Programming Type of Keys
In "Programming Call Keys" A press and hold down the PROG key on the power
supply 6 until you go into the "Programming Type of Keys" procedure G .
Exiting Programming
Briefl y press the PROG button. The PROG LED switches off .
☞
If no action is performed, the procedure will end automatically after 30
minutes.
Continue, repeating the same operations for all the other
receivers. The operation may only be carried out from the
entry panel with the active beep signal (PE1 in fi g.
2 ): to
change the entry panel from which the call programming
is carried out, press one of the call keys for at least 3
seconds.
Programming call keys
Press the door release and AUX2 buttons at the same time 3 . On the entry
panel, press the call key to be linked to the receiver 4 : a beep will confi rm that
the setting has been stored.
Going into Programming
Press the PROG key on the power supply
A
until the PROG LED lights up. The
PROG LED and key back lighting will fl ash
2
. Wait 5 seconds for the auto test
to be completed and continue as shown below.
Reprogramming