CAME LVC/01, Руководство по программированию, Страница: 5 / 16

C C
E
4
M2
SW3
PROG
R
ESET
PROG
M2
SW3
PROG
PROG >3’’ >3’’
<6’’ <6’’
BOUT
PROG
PROG P
2 2
beep beep
M2
SW3
PROG
R
ESET
PROG
M2
SW3
PROG
PROG
<1’’ <1’’
F F
M2
SW3
PROG
R
ESET
PROG
M2
SW3
PROG
PROG >3’’ >3’’
<6’’ <6’’
BOUT
PROG
PROG P
G G
M1
BOUT
PROG
M1
BOUT
PROG
8 8 9 9
1 1
Page
5
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
5
- Manual
FA01725-EN
- 03/2022 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Continue, repeating the same operations for all the other receivers.
Exiting Programming
Press the PROG button briefl y E . The PROG LED switches off .
☞
If no action is performed, the procedure will end automatically after 30
minutes.
Programming Type of Keys
In "Programming Call Keys", press the PROG key for at least 3 seconds F and
then release it (within 6 seconds) as soon as the PROG LED lights up and the
key back lighting fl ashes as illustrated in fi gure
G , entering "Programming
Type of Keys".
Press the fi rst key on the entry panel in the position shown
8 until the back
lighting LEDs stop fl ashing I and stay on.
At the end, to exit programming, briefl y press the PROG key E : the PROG LED
switches off .
If no action is performed, the procedure will end automatically after 30 minutes.
Programming call keys
Press the door release and AUX2 buttons C at the
same time.
On the entry panel, press the call key to be linked to the
receiver
4 : a beep will confi rm that the setting has been
stored.
Going into Programming
Press the PROG key for at least 3 seconds 1 and then release it (within 6
seconds) as soon as the PROG LED fl ashes and the key back lighting lights up
as illustrated in fi gure
2 .
Reprogramming