M1
BOUT
PROG
M
PROG
PROG
1
>3’’
M1
BOUT
PROG
M1
BOUT
PROG
M1
BOUT
PROG
3
3
3
3
A
3
3
B
2
2
M1
BOUT
PROG
4
4
beep
beep
E
E
F
F
beep
beep
M
PROG
PROG
G
<1’’
Page
7
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Page
7
- Manual
FA01725-EN
- 03/2022 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
Programming call keys
Press the door release
and AUX2 buttons at the same time
5
. On the entry
panel, press the call key to be linked to the receiver
6
: a beep will confi rm that
the setting has been stored.
Continue, repeating the same operations for all the other receivers.
Exiting Programming
Briefl y press the PROG button on the power supply
G
. The PROG LED switches
off and the entry panel stops ringing.
☞
If no action is performed, the procedure will end automatically after 30
minutes.
Going into Programming
Press the PROG button on the power supply
1
until the PROG LED lights
up. Failure of the PROG LED to light up, indicates a malfunction. Check the
connections and return to programming. The PROG LED and key back lighting
will fl ash
2
.
Wait 5 seconds for the auto test to be completed and continue as shown below.
Programming Type of Keys
Press the fi rst key on the entry panel in the position shown
3
/
3
A
3
B
until the
back lighting LEDs stop fl ashing
4
and stay on. A beep sounds to signal that
you have entered "Programming call keys".
PROGRAMMING ENTRY PANELS WITH VA/01
First Programming with one entry panel