Page
21
- Manual
FA01798-EN
- 01/2023 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
PROGRAMMING
Programming button functions
Esc
<
>
Ent
1
ESC button
The ESC button is used to perform the operations described below.
Exit the menu
Delete the changes
Go back to the previous screen
Stop the operator
2
< > buttons
The <> buttons are used to perform the operations described below.
Navigate the menu
Increase or decrease values
Open or close the operator
3
ENTER button
The ENTER button is used to perform the operations described below.
Access menus
Confirm choice
Getting started
Once the electrical connections have been made, proceed with commissioning. Only skilled and qualified staff may perform this operation.
Make sure that there are no obstacles in the way.
Power up the device and follow the instructions on the display.
Start programming following the wizard.
If this is not the first time the board is being switched on, go to the menu Configuration > Wizard. Follow the indications shown on the display.
Complete programming and check the warning, safety and protection devices, and the manual release, are working properly.
After powering up the system, the first manoeuvre is always to open the gate Wait for the manoeuvre to be completed.
Press the ESC button or STOP button immediately in the event of any faults, malfunctions, strange noises or vibrations, or unexpected behaviour in the system.
Functions menu
Menu layout
Some options only show on the display if certain conditions are met. For more information, please see the information for the individual functions.
Level 1
Level 2
Level 3
Level 4
Configuration
Motor settings
Opening direction
Motor test
Travel calibration
Motor type
