4
Top Handle Installation
Top mount
Bottom mount
Quick Release Clamping
open
closed
1. Open the quick release clamp.
2. Insert the top mount into bottom mount.
3. Close the quick release clamp and check that it is secure.
Camera Installation
Please be sure that the camera sits well on the quick release plate, then attach the QR plate to the
fixed plate.
1/4 screw
Quick release plate
1. Attach the quick release plate to your camera using the 1/4" screw
，
make the adjustment according to the
camera center of gravity.
2
. Attach the fixed block to the fixed plate and insert the quick release plate with the camera into the fixed plate
engaging the dovetail and then slide the camera back while pressing the release button to allow the camera
to slide into the fixed plate (See picture 2 for arrow direction).
3. Balance and use the handle adjustment screw to fix the quick release plate.
Fixed Block
Fixed Plate
Handle Adjustment Screw
quick release button
Pic 2
Pic 1
Balancing Gimbal
To achieve the best performance from the CAME- Single, proper balancing is necessary and a must. Accurate
balance is critical in shots where the CAME- Single will be subjected to extreme movements or accelerations
(running, horseback riding, biking, car mounts, helicopters, etc.) Proper balance will also offer a longer
battery runtime . There are 3 axes that need to be accurately balanced prior to powering the CAME- Single
on and setting up the software. Visit
http://www.cametvblog.com/category/faq
for videos on how to
properly balance your gimbal.
The camera needs to be fully setup with all accessories prior to installing and balancing the camera
on the gimbal. If you are balancing camera with a lens cap on, be sure to remove the lens cap prior
to balancing. Be sure whenever balancing the camera that the CAME- Single’s power is turned off.
1. Loosen the adjustable screw of the handle on the fixed plate, and use the fixed plate chute to balance the
camera forward and backward
.
2. After well balanced adjustment, feel free to pitch (tilt) the angle of the camera. If balanced correctly, it should
hold steady in any corresponding tilt position.
Step 1: Balancing the pitch Axis
5
Battery Preparation
Charger Specification
Input voltage support: 100-240V
，
50/60Hz
Output plug type: 3.5mmx1.35mm DC
Power output: 12V-1000mA
Output cable length: 1 meter
The gimbal comes with a built-in battery, please charge before usage.
1. Connect the charger adapter with socket.
2.
Make sure the gimbal is powered off
during the charging process.
3.
Depending on its current battery life, a full charge can be achieved in 3-4 hours.
The LED indicator light on the charger plug will switch from red to green once the battery is fully charged.
Once charge is complete, disconnect battery charger from gimbal. Do NOT overcharge.
Power button
Charger port
DC12V DC3.5 1.35mm Charger
socket or
adapter