CAME BPT 60090010, Руководство по программированию

Страница: 25 / 64

2
4
5
XX
beep
+
6
M1
A
PROG PROG >3’’
K
M1 A
PROG PROG
>3’’
1
M1
A
PROG PROG
>3’’
3
Pa
ge
9
- M
an
ua
l
FB
00
86
5-
EN
- v
er
.
1
- 0
8/
20
17
- © C
am
e S
.p
.A
. - T
he c
on
te
nt
s o
f t
he m
an
ua
l a
re t
o b
e c
on
si
de
re
d a
s s
ub
je
ct t
o c
ha
ng
e a
t a
ny t
im
e a
nd w
ith
ou
t t
he n
ee
d f
or a
ny a
dv
an
ce w
ar
ni
ng
.
If all the entry panels are reprogrammed, the configuration will be as shown in figure
J
. To exit reprogramming, briefly press the PROG key on the power supply
K
: the
PROG LEDs and the LEDs on the entry panels will go out. If no action is performed, the
procedure will end automatically after 30 minutes.
Programming entry panel video cameras. While programming the call keys the "visual range" of the video camera can be adjusted
in the way already described.
Entry panel brightness level adjustment. While programming the call keys the entry panel brightness level can be adjusted in the
way already described.
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, proceed as shown in the NOTE on page 6.
WARNING. If an entry panel is added, replaced or moved, the modifications are acquired by going into "Programming Type
of Keys" (from figure
6
-
K
).
Programming with DNA
1
2
3
4
5
6
7
8
9
10
For this type of configuration of Entry
panels refer to the procedures already
described.
For this type of configuration of Entry panels refer
to the procedures described below.
Entering Programming Mode.
Press the PROG key on the power supply for more than
3 seconds
1
. The LEDS on the entry panels light up as shown in figure
2
. If the PROG
LED immediately goes out, this indicates a malfunction in the connections between the
power supply and the entry panel. Check the connections and return to programming.
Repeat the operation
3
a second time. Check that the configuration on the Entry panels
is as shown in figure
4
. Wait 5 seconds for the auto test to be completed and continue
as shown below.
Programming the call codes. Press the door release and
AUX2 buttons
5
. Enter the call code for the group (from 1
to 99), followed by the key
6
to link the call code to the
receiver. Continue, repeating the same operations for all the other
receivers. The operation can only be carried out from the entry
panel with the LED off (PE1
4
): to change the entry panel
from which to carry out the programming of calls, press key 1
followed by the key.
1 P.E 2 P.E 3 P.E
1 P.E 2 P.E 3 P.E