CV-TAC400 Installation Guide |
56
File: CV-TAC400_IN_MAN__NF_REV6.doc
Revised: September 2, 2014
Part No: 40-82B113
15. Set the Facility Code
The CV-TAC400 is pre-programmed with Camden facility codes. The facility code does not need to be
set if Camden proximity cards are used.
To add or change a facility code, follow the steps below:
a.
Select the “View/Edit Data Records” Menu. A list of submenus will be displayed
b.
Select the “Configuration Settings” submenu. The Configuration setting window will be displayed.
Do not change the CV-TAC400 Address field at the top of the window.
c. Select the Misc tab. The miscellaneous tables will be displayed.
d. In the Facility Code table select (double click) the Facility Code entry you wish to edit.
e.
Enter the Facility Code and then press “Enter”
Note: Adding a Facility code is done by repl
acing one of the “0” entries with the Facility Code you wish to add.
Zero is not a valid facility code
f. When all the entries have been completed, select the Save button.
g. To close the Form select the Close button
h. Save and Upload the changed information.
