Camco Q-POWER 14, Руководство пользователя

Страница: 28 / 42

2 8 / 4 2 www.camcoaudio.com U S E R M A N U A L
Q - P O W E R 14
|
P O W E R A M P L I F I E R
11
S P E C I F I C A T I O N S
Q-POWER 14
Frequency response
@ 4 Ω load with 120 W ouptut power
10 Hz – 20 kHz: ± 0,1 dB
THD+N over frequency
@ 4 Ω load with 120 W output power
20 Hz – 8 kHz: < 0,1 %
Damping factor
8 Ω load, 1,7 kHz and below
400
Input impedance
15 kΩ balanced
Amplifier gain Selectable: 26 dB, 32 dB, or 1,4 V input sensitivity
Maximum analogue differential input level
+22 dBu / 9,75 V
RMS
/ 13,8 V
Peak
Level attenuation Individual volume control knobs for each channel
Minimum loudspeaker load impedance
Zmin = 2 Ω
Lower values are safe, but out of specification. No performance guarantees
can be given when driving lower impedances than specified.
Protection circuits SMPS: Mains Overvoltage Detection, Mains Surge Overvoltage Protection, Mains Failure Detection,
Overcurrent Protection, Thermal Protection
Amplifier: Temperature Dependent SOA Protection, DC Protection, Thermal Protection, Short Circuit Protection,
High Frequency Protection
Limiters
SMPS: Mains Inrush-Current Limitation, FuseProtect™ Limiter (with selectalbe MCB),
Mains Overcurrent Limitation
Amplifier: Clip Limiter (individually selectable for channels A+B and C+D),
Underimpedance Limiter, Output Current Limiter, Thermal Limiter
Cooling Three speed-controlled axial fans (temperature dependent)
LED indicators LEDs for ON, SIGNAL/Protect (multifunctional), I-OUT output current,
and CLIP (multifunctional) for each channel
Input connectors Four 3-pin XLR connectors,
Four 3-pin Euroblock connectors
Output connectors Four 4-pole SPEAKON ® connectors for each output channel (bi-amping possible for channels A/B and C/D)
Update and Service connectors One USB Type B connector for firmware update and MCB selection/programming,
One 10-pole header connector (for service only)
We reserve the right to make technical alterations without prior notice.