Camco Q-POWER 14, Руководство пользователя

Страница: 12 / 42

1 2 / 4 2 www.camcoaudio.com U S E R M A N U A L
Q - P O W E R 14
|
P O W E R A M P L I F I E R
3
M A I N S S U P P L Y
3. Mains
3.1 Mains Supply
The Q-POWER 14 ’s power supply is a true wide-range SMPS with active power
factor correction (PFC). This means that it can be operated anywhere in the
world without the need of any manual voltage range setting.
When mounting or connecting the amp always disconnect it from mains. Only
connect the
Q-POWER 14
amplifier to an appropriate AC circuit, according to the
requirements indicated in the second line on the rating plate.
3.2 Mains Plugs and Cables
Only use mains cables with original Neutrik ® powerCON ® 32 A connectors for
safety reasons.
l NOTE
Please never unplug the powerCON ® cable from the amplifier while it is still
carrying live voltage. Even if the amplifier is switched off!
Unplugging must always be done on the other end of the mains cable (i.e. with
the wall outlet plug*, or by the installation circuit breaker(s)).
The reason ist that the powerCON
® connector is not designed for disconnecting
live voltages, as this might deteriorate it’s contact performance over time.
* provided the connector is suited as a disconnect device, as for example the “Schuko”
plug used in Europe or the Twist-Lock plugs used in North America
l NOTE
Please make sure to always use appropriate mains cables and wall outlet
plugs offering sufficient current rating.
à
See also chapter 3.7 for more details on current rating and circuit breaker selection.
And of course do never remove the protective earth conductor, under any cir-
cumstances. The
Q-POWER 14 must always be connected to a socket with a
protective earth connector.
! WARNING
DO NEVER REMOVE OR DISCONNECT THE MAINS GROUND/EARTH
CONNECTION. IT IS ILLEGAL AND DANGEROUS!
3.3 On / Off Switch
The On / Off Switch is a rocker-type switch. It is located on the right side of
the front panel. To turn the amplifier on, press on the upper part of the switch.
During power up the Clip- and Signal-LEDs of all channels will light up in red for
a few seconds. To turn the amplifier off, press on the lower part of the switch.
Amplifier is switched on Amplifier is switched off
l NOTE
This switch does NOT disconnect the amplifier from mains.
Disconnecting the amplifier from the mains can only be achieved by disconnect-
ing the mains plug or by the installation circuit breaker(s).
The mains plug or circuit breaker(s) therefore have to be freely accessible at all
times. Disconnect the mains plug from the mains during a thunderstorm or when
the amplifier remains unused or unsupervised for a prolonged period of time.
While switched off and still connected to mains, the Q-POWER 14 will have an
average power consumtion of less than 2 W.

   
     
Q-POWER 14
100 - 240 V ~ 50/60 Hz 2200 W
3000 W / 2,7 Ohm