5
INSTALLATION INSTRUCTIONS (cont.)
7. Hang heater on the screws, and allow
to slide into place.
8. Check for clearance. If adjustment is
necessary, remove heater and loosen
or tighten screws. Repeat steps 7 and
8 until heater is firmly mounted.
NOTE: Screw head should be
approximately 5/16" from wall
to ensure tight installation.
9. Connect heater to the gas supply.
The installation must be made so that
the gas supply shut-off valve at the
heater is readily accessible.
Recessed Horizontal or
Vertical Installation
Olympian™ Wave 6 and Wave 8 Heaters may be recessed
into the wall in either the horizontal or vertical position.
Follow these easy mounting steps:
1. Purchase Chrome Recess Mounting Kit 57692 for the
Wave 6 or Kit 57695 for the Wave 8.
2. Using the Template supplied with Recess Mounting
Kit, carefully trace outline of cutout onto the area to
be removed.
BE SURE THERE ARE NO ELECTRIC,
WATER OR GAS LINES IN AREA TO BE CUT OUT.
3. Cut out and remove wall section.
4. Slip the mounting ring over the face of the heater until the
distance from the front of the recess ring to the back of
the case is 1-3 ⁄4". This is the maximum recess depth.
5. Using the ring as a template, carefully drill 7/64" diameter
screw holes through the heater case at the side and top.
Be careful of internal gas lines.
6. Fasten the recess mounting ring to the heater case, using
the #6 x 3/8" lg panhead tapping screws included in the
recess mounting kit.
7. Fasten the heater and mounting ring assembly to the wall,
using #6 x 3/8" lg panhead tapping screws.
8. Connect the heater to the gas supply. The installation
must be made so that the gas supply shut-off valve at the
heater is readily accessible. (Refer to page 5 of Installation
Instructions:
Heater Connection
.)
Outdoor Portable use of Heater
Optional leg stands may be purchased to allow portable use
of your Olympian Wave Heater. Order #57701 Leg Stand Kit.
For most portable installations the heater is used with a
standard 20 lb. or less gas capacity LP Gas cylinder fitted
with an LP Gas hose, low pressure regulator, and cylinder
connector.
The Wave 3 Olympian Heater is not designed to be
operated in a recessed position. Such an installation
could cause overheating and the danger of fire.
Recommended
Installation
For Recommended
Installation do not
exceed 1-3/4" from
the back of the heater
to the front of the
recess ring.
1-3/4" Max.
