page
8
of
17
EtherSync User Guide
document revision 1.01
Note
Hostname is not case-sensitive and must
be unique. We recommend using a
‘Friendly Name’ appended with the mac
address minus the colons, such as
CambrionixXXYYZZ.
The host name will change after
successful reboot, which is initiated at
the bottom of the
Systems>>Boot up and
Shutdown
section.
Note
To reset EtherSync back to the factory settings, switch on the power and insert a pin into
the pin hole circled below. Hold the pin in the hole until the two red lights flash
simultaneously, this could take up to ten seconds. After this turn the power off and on
again, the settings should now be reset to factory settings. This means that the name,
webmin username and password are as described above.
To download the EtherSync Connector Software go to https://hub.cambrionix.com/pages/ethersync and
follow the on screen instructions. For OS X it is the .dmg file; for Windows it is either the 32 or 64 bit
application depending on your system.
The application will no
t close if the ‘X’ is clicked.
Instead, it will sit in the easy access tray. To display the
application again, click on the item and select show; to close, select quit.
In order for EtherSync hubs to be displayed on the connector software both the EtherSync and host
computer need to be on the same subnet. If they are not they will need to be specifically added as shown
below.
1)
Open the EtherSync Connector
application. Right click on ‘USB Hubs’ to
bring up the menu and select ‘Specify
Hubs…’
.
Содержание EtherSync
Страница 1: ......
