CAMBER FSR SERIES, Руководство пользователя

Страница: 13 / 20

10
INTERNAL CABLE ROUTING
The Internal Cable Routing (ICR) system has internal tubes molded into the down tube to route the cables cleanly
and easily. Each hole has an optimal component (see fig.1).
• Carbon frames: Full down tube internal routing (
Shifter(s), rear brake, Command Post
)
• Alloy frames: Partial down tube internal routing (
Shifter(s), Command Post
)
If running a Command Post IR, it is recommended to refer to the Command Post IR
Adjustable-Height Seatpost Instruction Guide or other dropper post instruction guide, and complete
the installation of the dropper post cable housing before installing any other cable housing.
CARBON FRAME
„
Use the SWAT Storage door and exit port at the base of the down tube to access and guide the derailleur and brake
housings through the exit port hole and the Command Post housing up the seat tube. It is recommended to run all
housings into the frame starting at the head tube.
„
Though all housings will fit in any of the down tube routing tubes, Specialized recommends that the housings cross
each other and enter in the housing ports on opposite sides of the frame.
„
Trim each housing so that the handlebar can rotate 90 degrees in each direction, and that the distance between
the housing loops and the bottom bracket shell is 35-45mm (fig.2).
„
Refer to the brake manufacturer’s instruction guide for internal routing installation and bleeding information.
„
Once the brake and shifter installation is complete, tighten the exit port housing retainer bolt, just tight enough to
hold the housing loops in place.
„
Install the brake housing retainer clip on the underside of the chainstay.
REAR DERAILLEUR
REAR BRAKE
FRONT DERAILLEUR
COMMAND POST
HOUSING
RETAINER
BOLT
1
35-45mm
2