Electric Pizza Ovens
– Mod. “MS”
Ed.
1/2012 Rev.0 -
15
ENG
Temporarily attach the legs (1, 2, 3, 4) to the sheet-metal shelf by placing the
screws (A) in the lowest hole, as shown in the figure, and then screw on the nuts
without tightening them completely.
Attach the short sections (5, 6) to the legs by placing the screws in the upper
holes.
Attach the long lateral sections (7, 8) to the legs by means of the proper screws.
At the ends of the legs adjust the four leveling screws (B) so as to level the unit
well even on uneven surfaces.
Proceed to finish tightening the screws while using a square or a level to check that
the legs are in a perpendicular position and that the shelf is level. Tighten all the
screws very well.
2.3 Connection to the electrical power supply
The electrical connection to the power supply and the operation of
the machine must be done, pursuant to the law, only by a qualified
technician, who will previously check (IEC standards), with suitable
means and tools, the effectiveness of the ground electrodes and the
earthing system to which the device will be connected.
For installations outside the national territory, observe strictly the
regulations in force in the country where the machine will be used.
Make the connection following the provided technical manners, respecting both the
cyclic sequence of phases of connection, and the color coding of conductors.
